Source note · Setting up analog devices and ATAs on Webex Calling
After the device management URL is set, the VG4xx ATA displays its MAC address; the documented order is to record it, add it to Control Hub, run 'write memory', connect port GE 0/0/0 to a network with DHCP and internet access, and wait about five minutes for the configuration to complete.
Checked 2026-09-30
- Vendor
- Cisco
- Product
- Cisco VG4xx ATA
- Subsystem
- onboarding
- Deployment
- multi-tenant
- Region
- not restricted
- Release range
- current as of 2026-09-30
- Checked
- 2026-09-30
Sources
- Configure your Cisco Voice Gateway VG400, VG410, or VG420 in Control Hub — Cisco · tier 2 current vendor documentation · section 'Manually configure the VG4xx ATA', Webex configuration steps 3 to 7
Cite this note
APA
WarmTransfer. (2026, September 30). Setting up analog devices and ATAs on Webex Calling: source note webex-calling-analog-ata-setup-vg-onboard-sequence. WarmTransfer. https://warmtransfer.net/knowledge/claims/webex-calling-analog-ata-setup-vg-onboard-sequence
BibTeX
@misc{warmtransfer-claim-webex-calling-analog-ata-setup-vg-onboard-sequence,
title = {Setting up analog devices and ATAs on Webex Calling: source note webex-calling-analog-ata-setup-vg-onboard-sequence},
author = {{WarmTransfer}},
year = {2026},
url = {https://warmtransfer.net/knowledge/claims/webex-calling-analog-ata-setup-vg-onboard-sequence},
note = {Source note webex-calling-analog-ata-setup-vg-onboard-sequence, checked 2026-09-30}
}